[PDF&VCE] Lead2pass Cisco 200-125 Exam Dumps Free Download (361-380)

2016 September Cisco Official New Released 200-125 Dumps in Lead2pass.com!

100% Free Download! 100% Pass Guaranteed!

Lead2pass is the best place for preparing IT exam as we are providing the latest and guaranteed questions for all certifications. We offer you the ultimate preparation resource of Cisco 200-125 exam questions and answers. Wondering what could be this effective? It is our Cisco 200-125 VCE and PDF which serves as a guide to pass Cisco 200-125 exam.

Following questions and answers are all new published by Cisco Official Exam Center: http://www.lead2pass.com/200-125.html

QUESTION 361
A network administrator is explaining VTP configuration to a new technician. What should the network administrator tell the new technician about VTP configuration? (Choose three.)

A.    A switch in the VTP client mode cannot update its local VLAN database.
B.    A trunk link must be configured between the switches to forward VTP updates.
C.    A switch in the VTP server mode can update a switch in the VTP transparent mode.
D.    A switch in the VTP transparent mode will forward updates that it receives to other switches.
E.    A switch in the VTP server mode only updates switches in the VTP client mode that have a higher
VTP revision number.
F.    A switch in the VTP server mode will update switches in the VTP client mode regardless of the
configured VTP domain membership.

Answer: ABD

QUESTION 362
Refer to the exhibit. Both switches are using a default configuration. Which two destination addresses will host 4 use to send data to host 1? (Choose two.)
3621

A.    the IP address of host 1
B.    the IP address of host 4
C.    the MAC address of host 1
D.    the MAC address of host 4
E.    the MAC address of the Fa0/0 interface of the R1 router
F.    the MAC address of the Fa0/1 interface of the R1 router

Answer: AF

QUESTION 363
What are two reasons a network administrator would use CDP? (Choose two.)

A.    to verify the type of cable interconnecting two devices
B.    to determine the status of network services on a remote device
C.    to obtain VLAN information from directly connected switches
D.    to verify Layer 2 connectivity between two devices when Layer 3 fails
E.    to obtain the IP address of a connected device in order to telnet to the device
F.    to determine the status of the routing protocols between directly connected routers

Answer: DE

QUESTION 364
Refer to the exhibit. The router has been configured with these commands:
3641
What are the two results of this configuration? (Choose two.)
3642

A.    The default route should have a next hop address of 64.100.0.3.
B.    Hosts on the LAN that is connected to FastEthernet 0/1 are using public IP addressing.
C.    The address of the subnet segment with the WWW server will support seven more servers.
D.    The addressing scheme allows users on the Internet to access the WWW server.
E.    Hosts on the LAN that is connected to FastEthernet 0/1 will not be able to access the Internet
without address translation.

Answer: DE

QUESTION 365
A company is installing IP phones. The phones and office computers connect to the same device. To ensure maximum throughput for the phone data, the company needs to make sure that the phone traffic is on a different network from that of the office computer data traffic. What is the best network device to which to directly connect the phones and computers, and what technology should be implemented on this device? (Choose two.)

A.    hub
B.    router
C.    switch
D.    STP
E.    subinterfaces
F.    VLAN

Answer: CF

QUESTION 366
What are two benefits of using VTP in a switching environment? (Choose two.)

A.    It allows switches to read frame tags.
B.    It allows ports to be assigned to VLANs automatically.
C.    It maintains VLAN consistency across a switched network.
D.    It allows frames from multiple VLANs to use a single interface.
E.    It allows VLAN information to be automatically propagated throughout the switching environment.

Answer: CE

QUESTION 367
Which two statements are true about the command ip route 172.16.3.0 255.255.255.0 192.168.2.4? (Choose two.)

A.    It establishes a static route to the 172.16.3.0 network.
B.    It establishes a static route to the 192.168.2.0 network.
C.    It configures the router to send any traffic for an unknown destination to the 172.16.3.0 network.
D.    It configures the router to send any traffic for an unknown destination out the interface with the
address 192.168.2.4.
E.    It uses the default administrative distance.
F.    It is a route that would be used last if other routes to the same destination exist.

Answer: AE

QUESTION 368
What are two advantages of Layer 2 Ethernet switches over hubs? (Choose two.)

A.    decreasing the number of collision domains
B.    filtering frames based on MAC addresses
C.    allowing simultaneous frame transmissions
D.    increasing the size of broadcast domains
E.    increasing the maximum length of UTP cabling between devices

Answer: BC

QUESTION 369
Refer to the exhibit. A network associate needs to configure the switches and router in the graphic so that the hosts in VLAN3 and VLAN4 can communicate with the enterprise server in VLAN2. Which two Ethernet segments would need to be configured as trunk links? (Choose two.)
3691

A.    A
B.    B
C.    C
D.    D
E.    E
F.    F

Answer: CF

QUESTION 370
Which two values are used by Spanning Tree Protocol to elect a root bridge? (Choose two.)

A.    amount of RAM
B.    bridge priority
C.    IOS version
D.    IP address
E.    MAC address
F.    speed of the links

Answer: BE

QUESTION 371
Refer to the exhibit. The networks connected to router R2 have been summarized as a 192.168.176.0/21 route and sent to R1. Which two packet destination addresses will R1 forward to R2? (Choose two.)
3711

A.    192.168.194.160
B.    192.168.183.41
C.    192.168.159.2
D.    192.168.183.255
E.    192.168.179.4
F.    192.168.184.45

Answer: BE

QUESTION 372
Which three statements are typical characteristics of VLAN arrangements? (Choose three.)

A.    A new switch has no VLANs configured.
B.    Connectivity between VLANs requires a Layer 3 device.
C.    VLANs typically decrease the number of collision domains.
D.    Each VLAN uses a separate address space.
E.    A switch maintains a separate bridging table for each VLAN.
F.    VLANs cannot span multiple switches.

Answer: BDE

QUESTION 373
Refer to the exhibit. Which three statements are true about how router JAX will choose a path to the 10.1.3.0/24 network when different routing protocols are configured? (Choose three.)
3731

A.    By default, if RIPv2 is the routing protocol, only the path JAX-ORL will be installed into the routing table.
B.    The equal cost paths JAX-CHI-ORL and JAX- NY-ORL will be installed in the routing table if RIPv2
is the routing protocol.
C.    When EIGRP is the routing protocol, only the path JAX-ORL will be installed in the routing table by default.
D.    When EIGRP is the routing protocol, the equal cost paths JAX-CHI-ORL, and JAX-NY-ORL will be
installed in the routing table by default.
E.    With EIGRP and OSPF both running on the network with their default configurations, the EIGRP paths
will be installed in the routing table.
F.    The OSPF paths will be installed in the routing table, if EIGRP and OSPF are both running on the
network with their default configurations.

Answer: ADE

QUESTION 374
Refer to the exhibit. Which three statements correctly describe Network Device A? (Choose three.)
3741

A.    With a network wide mask of 255.255.255.128, each interface does not require an IP address.
B.    With a network wide mask of 255.255.255.128, each interface does require an IP address on a
unique IP subnet.
C.    With a network wide mask of 255.255.255.0, must be a Layer 2 device for the PCs to communicate
with each other.
D.    With a network wide mask of 255.255.255.0, must be a Layer 3 device for the PCs to communicate
with each other.
E.    With a network wide mask of 255.255.254.0, each interface does not require an IP address.

Answer: BDE

QUESTION 375
Switch ports operating in which two roles will forward traffic according to the IEEE 802.1w standard? (Choose two.)

A.    alternate
B.    backup
C.    designated
D.    disabled
E.    root

Answer: CE

QUESTION 376
Refer to the exhibit. Given the output shown from this Cisco Catalyst 2950, what is the most likely reason that interface FastEthernet 0/10 is not the root port for VLAN 2?
3761

A.    This switch has more than one interface connected to the root network segment in VLAN 2.
B.    This switch is running RSTP while the elected designated switch is running 802.1d Spanning Tree.
C.    This switch interface has a higher path cost to the root bridge than another in the topology.
D.    This switch has a lower bridge ID for VLAN 2 than the elected designated switch.

Answer: C

QUESTION 377
Refer to the exhibit. This command is executed on 2960Switch:
2960Switch(config)# mac-address-table static 0000.00aa.aaaa vlan 10 interface fa0/1
Which two of these statements correctly identify results of executing the command? (Choose two.)
3771

A.    Port security is implemented on the fa0/1 interface.
B.    MAC address 0000.00aa.aaaa does not need to be learned by this switch.
C.    Only MAC address 0000.00aa.aaaa can source frames on the fa0/1 segment.
D.    Frames with a Layer 2 source address of 0000.00aa.aaaa will be forwarded out fa0/1.
E.    MAC address 0000.00aa.aaaa will be listed in the MAC address table for interface fa0/1 only.

Answer: BE

QUESTION 378
Which of the following describes the roles of devices in a WAN? (Choose three.)

A.    A CSU/DSU terminates a digital local loop.
B.    A modem terminates a digital local loop.
C.    A CSU/DSU terminates an analog local loop.
D.    A modem terminates an analog local loop.
E.    A router is commonly considered a DTE device.
F.    A router is commonly considered a DCE device.

Answer: ADE

QUESTION 379
What are two characteristics of Telnet? (Choose two.)

A.    It sends data in clear text format.
B.    It is no longer supported on Cisco network devices.
C.    It is more secure than SSH.
D.    It requires an enterprise license in order to be implemented.
E.    It requires that the destination device be configured to support Telnet connections.

Answer: AE

QUESTION 380
What are two security appliances that can be installed in a network? (Choose two.)

A.    ATM
B.    IDS
C.    IOS
D.    IOX
E.    IPS
F.    SDM

Answer: BE

Practise Lead2pass 200-125 braindumps and pass your exam easily. Lead2pass is number one company for real exam dumps. Download Lead2pass 200-125 exam questions and answers PDF file and prepare from our study material.

200-125 new questions on Google Drive: https://drive.google.com/open?id=0B3Syig5i8gpDbnNGVlNHTzJjcWc

2016 Cisco 200-125 exam dumps (All 545 Q&As) from Lead2pass:

http://www.lead2pass.com/200-125.html [100% Exam Pass Guaranteed]

Lead2pass Testking Pass4sure Actualtests Others
$99.99 $124.99 $125.99 $189 $29.99-$49.99
Up-to-Dated
Real Questions
Error Correction
Printable PDF
Premium VCE
VCE Simulator
One Time Purchase
Instant Download
Unlimited Install
100% Pass Guarantee
100% Money Back